Triton 9621 Operation Manual - Manual (Page 145)

5-103
S
ECTION
5 - M
ANAGEMENT
F
UNCTIONS
S INGLE -C ASSETTE C ASH D ISPENSER O PERATION M ANUAL
T
RITON
S
YSTEMS
, I
NC
.
M
ODELS
9600/9601/9620/9621
F
UNCTION
: PRIMARY ALARM NUMBER
F
ACTORY
D
EFAULT
: NONE
A
CCESS
I
NSTRUCTIONS
:
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Choose MORE.
4.) Select TRITON CONNECT.
5.) Select ALARM NUMBERS.
6.) Choose PRIMARY.
D
ESCRIPTION
:
The PRIMARY ALARM NUMBER function is used to enter the telephone number that the terminal
can use for calling a Triton Connect Host Computer to report alarm conditions.
NOTE: If no primary alarm number is entered, the terminal will default to the PRIMARY TRITON
CONNECT NUMBER when placing alarm-initiated calls.
When this function is selected, the current phone number is displayed (if nothing appears on the
screen, no number is set). Select CHANGE to blank the current entry, and then enter the desired
phone number. The phone number may be up to 30 digits long. It can also contain a dialing prefix,
such as a ‘9’ for an outside line, if necessary. If you need to pause after the prefix, place a comma
in the number for a two-second delay at that point. Pressing the key first, then the <0>
key, followed by the key to select the comma character. Make sure to enter
the long distance prefix ‘1’ if you are dialing an 800 number or a toll long distance number. Do not
enter dashes in the number.
E
RROR
C
ONDITIONS
::
There are no error conditions directly associated with this function.