AMT Datasouth 6000 - Manual (Page 76)

Fastmark 6000 Series User's Guide 75
Appendix C: PRINTER STATUS
LCD display Blinking LED Description
PAUSE READY The printer is in a pause state. Press
PAUSE or CANCEL to return to normal
state.
MEDIA OUT MEDIA
READY
The media is uninstalled or used up. Load
new media to the printer.
RIBBON OUT RIBBON
READY
The ribbon is uninstalled or end-of-ribbon
occurred. Load new ribbon to the printer.
If using Direct Thermal media verify that
Switch 1 is off.
SERIAL IO ERROR READY The format or baud rate of the RS-232
communication may be incorrect. Verify
host and switches 6 to 8.
CUTTER FAILED READY The cutter can not cut off the media, check
the media and cutter.
MEMORY FULL READY The printer buffer is full. Possibly caused
by the loaded soft fonts, graphics or forms.
Check the format of these data.
HEAD OPEN READY The printhead latch is not closed. To print
the label the head latch must be closed.
P. SENSOR O.R. READY The media sensor is out of range during
calibration. Make sure the media is
installed and the label sensor is put under
the media.