AMT Datasouth 6000 - Manual (Page 48)

Fastmark 6000 Series User's Guide 47
COMMAND QUICK REFERENCE
This section lists all software commands of the printer. For more information please refer to
the Programmer’s Manual.
Command Set for PPLA
The following commands are for Printer Programming Language A.
Note: In this quick reference all variable data is represented in Italics.
System Setting Commands
These commands will cause the related parameters to be saved in the non-volatile memory,
E2PROM. The parameters will be stored unless they are changed by another command,
or reset from the panel.
Command Description Parameter Factory default
KI4n Media empty check n : ‘0’ - disable,
‘1’ - enable.
Enabled
KI7n Set ribbon mode n : ‘0’ – DT,
‘1’ – TT.
TT with ribbon
KI8n Set baud rate n : ‘0’ – 9600,
‘1’ – 600,
‘2’ – 2400,
‘3’ – 19200,
‘4’ – 4800,
‘5’ – 38400,
‘6’ – 1200,
‘7’ – 9600.
9600 baud.
KI;n Control Code types n : '0' - selects standard control
codes.
'1' - Select alternate control
codes
KXnnnn Set continuous label
length nnnn : a 4-digit number, in mm
KI Set symbol set for ASD
smooth font set m : ‘0’ - USASCII,
‘1’ - United Kingdom,
‘2’ - Spanish,
‘3’ - Swedish,
‘4’ - French,
‘5’ - German,
‘6’ - Italian,
‘7’ - Danish/Norwegian. 0 for USASCII