AMT Datasouth 6000 - Manual (Page 23)

22 User's Guide Fastmark 6000 Series
10. Slide the green Outside Media Guide off the Front and Back Media Rails by pulling
straight out.
Figure 19 - Outside Media Guide
11. Thread the media over the Back Media Rail and under the Front Media Rail as shown
in Figure 20.
12. Continue feeding the media through the black Upper and Lower Media Sensor Arms
located under the print module.
13. Place the green Outside Media Guide (smooth side in) back onto the Front and Back
Media Rails.
14. Slide the Outside Media Guide towards the center of the printer until it just touches but
does not buckle the media.
Outside Media Guide
Side Support Door
Printhead Latch
Front Media Rail
Back Media Rail
Ribbon