AMT Datasouth 6000 - Manual (Page 29)

28 User's Guide Fastmark 6000 Series
Performing the Self Test
1. Power off the printer.
2. Make sure that 4 inch wide media is installed. The Self-test will print the maximum width
of the installed label.
3. Press and hold the FEED/Config button.
4. Power on the printer.
5. Release the FEED/Config button when:
The message “SELF TESTING…” is displayed on the LCD.
6. The printer will print a configuration page then feed to the first print position on the next
label.
7. The following information will be printed on this report.
- Font list
- DIP switch settings
- Hardware configuration and status
- Label parameters
- Firmware version
Note: Depending upon the length of the label the printer will print across multiple
labels. Some portions of the self-test may be printed upon the Gap between
labels. To print the self-test use a minimum 6 inch label length.
Note: The following figure is an example of the self-test.