AMT Datasouth 6000 - Manual (Page 45)

44 User's Guide Fastmark 6000 Series
Back Panel Switches
Any change in switch position is not registered until Power is cycled.
Standard Switch Settings
Switch
Number Function Position
setting Description
ON Ribbon is installed. Thermal transfer mode. Enables
end-of-ribbon detection. If end-of-ribbon occurs the
RIBBON and READY indicators will blink. 1 Thermal
Transfer
Ribbon
OFF Ribbon is not installed. Direct thermal.
ON Alternate control code set is printable 2 Standard
Control
Codes
OFF Standard control code set.
ON Cutter is installed. 3 Cutter
OFF Cutter is not installed.
ON The gap length is more than 4 mm. 4 Gap Size
OFF Media with normal gap or continuous media.
ON Peeler is installed. 5
OFF Peeler is not installed.