AMT Datasouth 6000 - Manual (Page 39)

38 User's Guide Fastmark 6000 Series
Procedure to Enter into Set-up Mode
1. Power on the printer.
2. When the “ READY” message is displayed on the LCD, press [PAUSE] and
the [CANCEL] buttons simultaneously.
Figure 25 - Entering into Set-up Mode
3. Press [PAUSE] button to scroll to the feature that you want to change.
4. Press [FEED] button to scroll to the desired value of the displayed feature.
5. Once the desired value is displayed, press [CANCEL] button to save it. After
pressing the [CANCEL] button an * should appear in the last column. The * is
used to designate the stored value in non-volatile memory (E2PROM).
6. Press both [PAUSE] + [CANCEL] buttons at the same time, to return to
normal mode.
Note: Do not enter set-up mode while the printer is printing or while the host is
sending data.
Next Value
Next Feature
Enter Value
Press to Enter / Exit Setup Mode