LumaSense Technologies IS 8-GS pro - Manual (Page 17)

Series 8 pro Manual Settings / parameter descriptions 17
4 Display functions / adjustment buttons
The pyrometers are equipped with extensive adjustment options for optimal
adaptation to the relevant measurement condition. They are controlled by the
adjustment buttons on the left side of the instrument.
4.1 Displays and adjusting special displays / parameters
Pressing the PARameter push button repeatedly brings up the
following functions one after the other. They appear in the bottom
left of the LC display in short form. The current setting is shown in the
bottom right.
Display Meaning Settings Brief description*
EMI Emissivity 10...100% Display and setting of the measuring object
emissivity
MAX Maximum value
display ON / OFF In addition to the measured value, show the
maximum value of the current measurement
process and save it if appropriate
AVG Average value
display ON / OFF In addition to the measured value, show the
average value of the current measurement
process and save it if appropriate
INT/SEC Interval [s] OFF,
1 ms...500 s
Display and setting of time interval for
storage of measured values during
continuous measurement
EMI DIRECT Direct
adjustment of
emissivity
ON / OFF Direct adjustment of the emisivity with
arrow keys in measuring mode
C/F Temp. display
in °C or °F °C / °F Set temperature display to °C or °F
MEM CELL# Show contents
of memory CELL# 1...
CELL# 4000...
BLOCK ... Display of stored measured values
Display of stored blocks
* For a detailed description see Chapter 5.
The arrow keys can be used to turn special displays on and off (maximum value display or
average value display) and to select available parameter values (show emissivity, storage
interval or stored measured values)
When the emissivity is set or stored measured values are called up, pressing and holding
the arrow keys causes the display to run through values in fast mode.
If a parameter has been changed with the arrow keys, it must be confirmed with the
ENTer key to be accepted. Changing to another parameter (with the PAR push button)
will not cause a value that has been changed with the arrow keys to be accepted. If no entries
are made for about 30 seconds, the pyrometer switches back to measuring mode without
accepting any parameter that may have been changed but not confirmed.
PAR ENT
PAR
ENT
PAR
°C