LumaSense Technologies IS 50-LO plus - Manual (Page 24)

IS 50-LO plus / IGA 50-LO plus Manual Parameter descriptions / settings 24
5.9 Wait time (t
w
)
Using a pyrometer with RS485 it is possible that the connection is not fast
enough to receive the pyrometer’s answer to an instruction of the master. In
this case, a wait time can be set to slow down the data transfer (e.g.: t
w
= 02
at a baud rate 9600 means a wait time of 2 /
9600
sec).
Note: Only available via interface commands, see Chapter 9, Data format UPP.
5.10 Maximum internal temperature (MaxIntTemp)
Shows the maximum internal temperature the device ever reached.
5.11 Error status (Status)
In case of a device error the pyrometer displays a hex code which identifies this error to
LumaSense service. The standard display at this point is “ok”.
Settings:
00 Bit
...
99 Bit