Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) - Manual (Page 29)

The Set Parameters window is displayed.
FIGURE 13 EZSwitchSetup Set Parameters window
Setting switch parameters
1. Follow the onscreen directions to set a new admin password for the switch. Make sure to record
your password and keep it in a secure location for future reference.
2. Optional: Enter a new name for the switch and set the correct date and time.
3. Click Next. The Select Zoning window is displayed.
Zoning selection options
The next step in configuring your switch is to select zoning. There are three choices:
• Typical Zoning creates a port-based zoning scheme based on the connections made on the
Configure Ports and Connect Devices window. This zoning scheme creates a two-member zone
for every possible pairing of HBA (H) and storage (S) ports connected on the Configure Ports and
Connect Devices window. This ensures that any host device connected to an H port is able to
communicate with any storage device connected to an S port.
Setting switch parameters
EZSwitchSetup Administrator’s Guide 27
53-1003129-01