Supported switches – Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) User Manual
Page 14
4.
Click Every time I visit the webpage in the Temporary Internet Files and History Settings
dialog box, as shown in following figure.
5.
Click OK to save the changes.
FIGURE 2 Configuring Internet Explorer
Supported switches
You can use EZSwitchSetup with the switches listed in
Supported hardware and software
on page 7.
Your switch must meet the following requirements:
•
The switch must be connected to an Ethernet LAN that is accessible by the host. If it is not, the
system issues the message “Page not Found.”
•
The switch must have licensed FC ports. If the switch has no licensed FC ports, you must first
install a Ports on Demand (POD) license and then enable the affected ports. For more
information, refer to
on page 47.
•
The switch must be in a single-switch fabric. If your switch connects to another switch (if there is
an E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
NOTE
If there is an E_Port on the switch and if there is a zone conflict, then the fabric is segmented; in this
case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch fabric.
You cannot use EZSwitchSetup to manage a switch that has any of the following features enabled:
Supported switches
12
EZSwitchSetup Administrator’s Guide
53-1003129-01