Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) - Manual (Page 17)

Setting Up Your Switch
● Installing and running the EZSwitchSetup wizard........................................................... 15
● Configuring the switch.....................................................................................................26
● Zoning selection options................................................................................................. 27
● Connecting devices and completing the setup................................................................30
Installing and running the EZSwitchSetup wizard
You can run EZSwitchSetup from a computer you are currently using for SAN administration, or you can
use a different computer that is not part of the SAN, such as a laptop. In this chapter, the computer
running EZSwitchSetup is called the setup computer.
The first step in setting up your switch is to install the EZSwitchSetup wizard, which is located on the
EZSwitchSetup installation CD.
1. Insert the EZSwitchSetup CD into the CD-ROM drive of your setup computer.
• On Windows: The installer will autostart in about a minute.
• On Linux: Navigate to the following path location on the CD-ROM:
CDROM_Path/CDROM_Installers/Linux/Disk1/InstData/VM/install.bin
2. Install EZSwitchSetup following the onscreen directions.
EZSwitchSetup Administrator’s Guide 15
53-1003129-01