beautypg.com

Launching the ezswitchsetup wizard – Brocade EZSwitchSetup Administrator’s Guide (Supporting 300, 5100, 5300, 6505, 6510, 6520, 7800, 7840, and VA-40FC) User Manual

Page 18

background image

Installation will take a few minutes after you click OK.

3.

Click Done on the last window (shown in the following figure) to exit the installer.

FIGURE 3 EZSwitchSetup Installer window

On Windows, EZSwitchSetup starts automatically after it is installed. If it does not, refer to

Launching the EZSwitchSetup wizard

on page 16 to launch the EZSwitchSetup wizard

manually.

On Linux, follow the procedure in

Launching the EZSwitchSetup wizard

on page 16 to launch

the EZSwitchSetup wizard.

Launching the EZSwitchSetup wizard

Perform the following, depending on your operating system:

On Windows: EZSwitchSetup starts automatically after it is installed. If it does not, then from the
Start menu, select Programs > EZSwitchSetup > EZSwitchSetup.

On Linux: EZSwitchSetup does not start automatically, so you must start it manually.

NOTE
The Linux installation requires root access.

Launching the EZSwitchSetup wizard

16

EZSwitchSetup Administrator’s Guide

53-1003129-01