Installing the ac power supply – Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) User Manual
Page 83
Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide
73
53-1003029-02
Power supply replacement
6
FIGURE 49
Removing the power supply from the device
5. Continue to pull the power supply until it is removed from the device.
6. Place the power supply in an anti-static bag for storage.
7. Insert a new supply, or place and screw in a cover plate over the empty power supply. Refer to
“Installing the AC power supply”
on page 73 for details.
Installing the AC power supply
Perform the following steps to install an AC power supply.
1. Remove the power supply or cover plate currently in the power supply bay you wish to install
the power supply in. Refer to
“Removing the AC power supply”
on page 72 for details.
2. Remove the new power supply from its packaging.
3. With one hand, support the underside of the power supply and insert the power supply into the
empty power supply slot. Press until the supply is completely in the slot, so that the connectors
on the back of the supply are fully engaged with the pins on the power backplane.