Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 43)

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 33
53-1003029-02
Installation precautions
3
Installation precautions
Follow these precautions when installing the unit.
DANGER
Risk of explosion if battery is replaced by an incorrect type. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Lithium battery is a long life battery
and it is very possible that you will never need to replace it. However, should you need to replace
it, do not dispose of the battery along with household waste. Contact your local waste disposal
agency for the address of the nearest battery deposit site.
CAUTION
All fiber-optic interfaces use Class 1 lasers.
CAUTION
Do not install the device in an environment where the operating ambient temperature might
exceed 40
o C (104 o F).
CAUTION
Make sure the air flow around the front, sides, and back of the device is not restricted.
CAUTION
Never leave tools inside the chassis.
Lifting precautions
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device at
the bottom and progressively place lighter devices above.