Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 47)

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 37
53-1003029-02
Redundant power supply installation
3
Redundant power supply installation
The Brocade device ships with one alternating-current (AC) power supply or direct-current (DC)
power supply. All models have two power supply slots, enabling you to install a second power supply
for redundancy. If desired, you can install a second supply for redundancy.
CAUTION
Changes or modifications made to this device that are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
If you need to install a redundant power supply, it may be easier to install it before mounting the
device, although the power supplies are “hot swappable” and can be installed or removed after the
device is mounted and powered on.
This section provides the following procedures:
• Installing a redundant AC power supply – “Installing an AC power supply” on page 37
• Installing a redundant DC power supply – “Installing a DC power supply” on page 39
Installing an AC power supply
DANGER
Before beginning the installation, refer to the precautions in “Power precautions” on page 34.
Use the following procedures for AC power supplies in Brocade NetIron CES 2000 Series, NetIron
CER 2000 Series 2000 series devices.