Yokogawa Removable Chassis DX1000N User Manual
Page 29
3-8
IM 04L41B01-03E
3.3 Switching Between Batch Overview Mode and
Batch Single Mode
Procedure
• Switching From Batch Overview Mode to Batch Single Mode
When Batch Overview Is Displayed
1.
Use the
arrow keys to select a batch group.
The selected batch group’s batch identification bar is displayed in blue.
2.
Press
DISP/ENTER to open the display selection menu.
3.
Use the
arrow keys to select BATCH VIEW.
4.
Press the
right arrow key to open the submenu.
5.
Use the
up and down arrow keys to select a display type, and press DISP/
ENTER.
The display changes to show only the selected batch group in the display type selected from
the submenu.
When Any Screen Other Than Batch Overview in Batch Overview Mode Is
Displayed
You cannot perform step 1 of this procedure. Instead, the batch group already
selected on the batch overview is used for steps 2 to 5.
• Switching From Batch Single Mode to Batch Overview Mode
Follow the procedure below when the batch single mode screen is displayed.
1.
Press
DISP/ENTER to open the display selection menu.
2.
Use the
arrow keys to select BATCH OVERVIEW, and press DISP/ENTER.
The batch overview is displayed.