Yokogawa Removable Chassis DX1000N - Manual (Page 21)

2-6
IM 04L41B01-03E
2.3 Using the Event Action Function
The event action function performs a specified action when a specified event occurs.
For example, you can use the event action function to write a message when an alarm
occurs. When you use the multi batch function, you have to specify the batch group
to perform the action on. In the above example, you could configure the DX to write a
message to batch group 2 when an alarm occurs. When you configure an action that
requires you to specify a batch group, a box for selecting the batch group is displayed.
Setup Example: Starting and Stopping the Recording of Batch Group 2
In the example below, the remote control function (/R1 and /PM1 options) is used to start
and stop the recording of batch group 2 according to the input received by remote control
input 1. Logic box number 1 is used.
• Setup Screen and Setup Items
Press MENU (to switch to setting mode), and select the Menu tab > Timer, Event action
> Event action.
Select 1.
Set the event to the reception of input by
remote control input terminal 1.
Set the action to the starting and stopping
of the recording of batch group 2.
* Setting Target Action to All specifies all the batch groups.
Starts and stops the recording of batch group 2 according to the input signal received by
remote control input terminal 1.