Watlow SpecView from Watlow - Manual (Page 37)

SpecView from Watlow  37  Watlow Addendum
EZ-ZONE Modbus Instruments
Watlow recommends using Standard Bus communications between SpecView and EZ-ZONE products
because there are many advantages including automatic detection. However, there are situations where it
may be preferable to use Modbus RTU or Modbus TCP. For these cases the following instruments are
offered. The tables below list the parameters supported by these instruments.
EZ-ZONE Alarm
State
High Set Point
Low Set Point
Clear Request
Silence Request
EZ-ZONE Analog Input
Input Value
Error Status
Cal Offset
Clear Latch
EZ-ZONE Communications
Display Units
Non-volatile Save
EZ-ZONE Control Loop
Control Mode
Control Mode Active
Heat Prop Band
Cool Prop Band
Time Integral
Time Derivative
Dead Band
Heat Hysteresis
Cool Hysteresis
Heat Power
Cool Power
Output Power
TRU-TUNE+ Enable
Autotune Request
Autotune Status
EZ-ZONE Current
Read
Reading RMS
Error
Heater Error
High Set Point
Low Set Point
EZ-ZONE Digital I/O
Input State
Output State
Direction
EZ-ZONE Limit
State
Status
Low Set Point
High Set Point
Clear Request
EZ-ZONE Set Points
Clsd-Loop Set Point
Open Loop Set Point
Clsd-Loop Working SP
Open Loop Working SP
Idle Set Point
Ramp Working SP
Ramp Target SP