Watlow SpecView from Watlow - Manual (Page 17)

SpecView from Watlow  17  Watlow Addendum
8) For the Port to
which the
controllers are
attached, choose the
appropriate protocol
driver in Protocol.
See the table below.
Note: If there are controllers
on the same port that
require different drivers,
you will need to repeat
steps 8 to 10 for each
protocol.
9) Click Start Scan.
For this Controller… Choose this Protocol
Driver… Notes
EZ-ZONE PM, RM or ST
Watlow EZ-ZONE
Standard Bus
SERIES 96, 97, SD
MICRODIN,
POWER SERIES,
986, 987, 988, 989
Watlow Modbus
SERIES F4 Ramping
Watlow Modbus
Watlow F4 Programmer
1
For the SERIES F4 Profiling controller, scan twice,
once with each protocol driver. Add the F4 Cascade
instrument manually if desired. See Manually Set up
or Modify a Modbus RTU, 485 or 232 Network on
page 22.
16CLS, 16MLS,
CLS216, MLS316
Anafaze 16 Loop
CLS200 and MLS300 Standard and Ramp/Soak
firmware options. For controllers with Ramp/Soak to
add the Anafaze Profile Status and the desired
Anafaze Profile instruments. See Manually Set up or
Modify a Modbus RTU, 485 or 232 Network on page
22.
32MLS, MLS332 Anafaze 32 Loop
8CLS, CLS208
4CLS, CLS204
Anafaze 8 Loop
32MLS (Anafaze protocol) Anafaze/AB
1
Scan with the Watlow F4 Programmer driver only if the F4 programmer option is enabled.