Watlow SpecView from Watlow - Manual (Page 26)

SpecView from Watlow  26  Watlow Addendum
Manually Set up or Modify an EZ-ZONE Modbus TCP
Network
The following procedures guide you through the process of configuring SpecView to communicate with
EZ-ZONE controllers via Modbus TCP and adding instruments to the configuration.
To create a new configuration:
1) Launch SpecView.
2) Click through any
informational dialogs
until you get to the
Configurations
Found dialog.
3) Click New Manual
Configuration.
4) Enter a name for the
configuration
5) Click OK.
To add one or more EZ-ZONE PMs to a configuration:
1) Open the Graphical
Display Window in
the configuration
mode if it is not
already open.
2) Click the Variables
button.