Watlow SpecView from Watlow - Manual (Page 23)

SpecView from Watlow  23  Watlow Addendum
4) Enter a name for the
configuration.
5) Click OK.
To add one or more instruments to a configuration:
1) Open the Graphical
Display Window in
the configuration
mode if it is not
already open.
2) Click the Variables
button.
3) Click Show New.
4) In the Variables list
click the button
next to the protocol
driver that includes
the instrument you
want to add. See the
table below.
5) Select the instrument
you want to add.
6) Click Add Item.
For This Controller…
From this Protocol
Driver…
Add These Instruments…
With Address
String…
EZ-ZONE PM Watlow Modbus
See Using EZ-ZONE Controllers with Modbus on
page 11.
EZ-ZONE PM Express
Controller
Watlow Modbus
EZ-ZONE PM Express
Limit
Watlow Modbus
EZ-ZONE RM Watlow Modbus
EZ-ZONE ST Watlow Modbus
MICRODIN Watlow Modbus MicroDin z,0
SERIES 96 Watlow Modbus Series 96 z,0
SERIES 97 Watlow Modbus SERIES 97 Limit z,0
SERIES SD Watlow Modbus
SERIES SD Controller z,0
SERIES SD Profiling 1 z,0
SERIES SD Limit Watlow Modbus SERIES SD Limit z,0