Watlow SpecView from Watlow - Manual (Page 19)

SpecView from Watlow  19  Watlow Addendum
Manually Set up or Modify an EZ-ZONE Standard Bus
Network
The following procedures guide you through the process of manually creating a configuration for a
Standard Bus network and adding devices to this configuration. Use this procedure when the EZ-ZONE
controllers are not available to detect automatically or when you want to add a new EZ-ZONE controller
to an existing configuration and therefore do not want to automatically create a new configuration.
To create a manual configuration:
1) Launch SpecView.
2) Click through any
informational dialogs
until you get to the
Configurations
Found dialog.
3) Click New Manual
Configuration.
4) Enter a name for the
configuration.
5) Click OK.