beautypg.com

Run a menu (without preheat feature) – Watlow MINICHEF 2000 Rotisserie Oven Application User Manual

Page 24

background image

2 2

Wa t l o w M

I N I

C

H E F

2 0 0 0

A p p l i c a t i o n 2 8

Temp 2 will run until Time 2 expires. You will not see the switch-over from Time 1 to
Time 2.

4.

When the cooking sequence is complete, the unit will switch to the Hold sequence.

An audible tone will sound for two seconds

The display will alternate slowly between [`Ho1d] and count up time.

The unit will count up time indefinitely. The hold sequence will end and the con-
troller will go into idle when you cancel the current menu by pressing the Start/Stop
key.

5.

Once the controller goes into idle, the Start/Stop key indicator light and heat output
will switch off. The controller will not regulate to any temperature.

6

To repeat cooking, repeat steps 1 through 4.

Run a Menu (without preheat feature)

This procedure describes how to run an active menu when the preheat feature is inac-
tive - in other words, when the [ready] parameter in the [setUp] function of the
Configuration mode is set to [```no].

1.

Set a menu as shown earlier.

2.

With idle on the display, place the food on the spit.

3.

Press the Start/Stop key.

The Start/Stop key indicator will light up. Time will count down on the display.

Depending on the way the controller was programmed at [Etype] / [Steps] the
unit will run either a one or a two step cooking sequence:

[Etype] / [Steps] = [````1]: One Step Cooking Sequence

[Etype] / [Steps] = [````2]: Two Step Cooking Sequence

One step cooking sequence:

Countdown time is displayed. It is the programmed Time 1.

Temp 1 will run until Time 1 expires.

Two step cooking sequence:

Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2.

Temp 1 will run until Time 1 expires.

Temp 2 will run until Time 2 expires. You will not see the switch-over from Time 1
to Time 2.

4.

When the cooking sequence is complete, the unit will switch to the Hold sequence.

An audible tone will sound for two seconds.

The display will alternate slowly between [`Ho1d] and count up time.

The unit will count up time indefinitely. The hold sequence will end and the con-
troller will go into idle when you cancel the current menu by pressing the Start/Stop
key.

5.

Once the controller goes into idle, the Start/Stop key indicator light and heat output
will switch off. The controller will not regulate to any temperature.

6.

To repeat cooking, repeat steps 1 through 4.