Watlow MINICHEF 2000 Rotisserie Oven Application - Manual (Page 23)

A p p l i c a t i o n 2 8 Wa t l o w M I N I C H E F 2 0 0 0 ■ 2 1
The word [pre-`] [`Heat] will appear on the display for a few moments. The
Start/Stop key indicator light will flash slowly. The temperature of Channel 1 will
be displayed until the operating temperature is reached.
The heat output indicator light - G, just below the display- will light up whenever
the controller is calling for heat.
When the oven is at operating temperature (above the relative set point minus the
ready band) [ready] will appear on the display and the Start/Stop key indicator
light will flash rapidly. You are now ready to cook with the active menu.
• If the oven is at operating temperature, the display goes directly to [ready] with-
out indicating preheat or temperature.
Note: You can skip preheat and go directly to the cooking sequence by pressing the Start/Stop key a second time.
Run a Menu (with preheat feature)
This procedure describes how to run an active menu when the preheat feature is active
- that is, when the [ready] parameter in the [setUp] function of the Configuration
mode is set to [~`yes].
1. Set a menu as shown earlier.
2. With [`idle] or time of day on the display, press the Start/Stop key.
If the preheat condition has not been met, the oven will preheat until ready appears
on the display.
Note: You can skip preheat and go directly to the cooking sequence by pressing the Start/Stop key a second time.
If the oven is already at operating temperature [ready] will appear on the display.
3. With [ready] on the display, place the food on the spit. Then press the Start/Stop
key (indicated by the rapidly flashing indicator light).
The Start/Stop key indicator will light up. Time will count down on the display.
Depending on the way the controller was programmed at [Etype] / [Steps] the
unit will run either a one or a two step cooking sequence:
[Etype] / [Steps] = [````1]: One Step Cooking Sequence
[Etype] / [Steps] = [````2]: Two Step Cooking Sequence
One step cooking sequence:
Countdown time is displayed. It is the programmed Time 1.
Temp 1 will run until Time 1 expires.
Two step cooking sequence:
Countdown time is displayed. It is the total of the programmed Time 1 plus Time 2.
Temp 1 will run until Time 1 expires.
A B
D E
C
F
G H
M INI C HEF 2000
[`idle]
Edit Accept
Back-Up Exit
SLOW
FLASH
AT OPERATING TEMPERATURE
(PREHEAT CONDITION MET)
RAPID
FLASH
B
D E
C
F
M INI C HEF 2000
[100f`]
Edit Accept
Back-Up Exit
B
D E
C
F
M INI C HEF 2000
[ready]
Edit Accept
Back-Up Exit
G H G H
A A
[pre-`] [`Heat]