Proface APL3000B - Node Box PC - Manual (Page 33)

PS-3650A / PS-3651A Reference Manual
2-12
„ Power-ON Configuration
Specify the setting of power-on operation. Point the cursor to the [Power-ON Configuration] on the
[Advanced] screen and press the [Enter] Key, so that the following screen will be displayed.
Power On Delay
Specify whether to set standby time before the system starts up. Select [Enabled] or [Disabled]. When
[Enabled] is selected, the system waits for 4 seconds before start-up. The factory default setting is [Disabled].
Power On Beep
Specify whether to sound a “beep” upon system boot-up. Select [Enabled] or [Disabled]. The factory default
setting is [Enabled].
• If a USB device such as USB memory is connected to the PS-A when the PS-A is started, the fol-
lowing phenomenon may occur, depending on the device:
• It takes about 1 minute before the OS starts up.
• The PS-A does not recognize the USB device.
These problems may be solved by setting [Power On Delay] to [Enable].