Proface APL3000B - Node Box PC - Manual (Page 26)

Chapter 2 System Setup
2-5
„ IDE Master / IDE Slave / SATA Port
Point out the cursor at the [Primary Master], [Primary Slave], [Secondary Master], or [Secondary Slave] on
the “Main screen”, and then press the [Enter] key, so that the following screen is shown.
Type
Specifies a type of drive which you use. Select from [Auto], [None], [ATAPI Removable], [CD-ROM],
[IDE-Removable], [Other ATAPI], or [User]. The factory default type is [Auto].
Total Sectors
Shows the number of disk sectors connected to the unit.
Maximum Capacity
Shows the maximum capacity of the disk connected to the unit.
Multi Sector Transfers
Specifies the number of sectors per block, which are transferred to the memory. When the [Type] is [None],
nothing is displayed. When [Type] is [Auto], the selection is disabled. In other cases, select from [Disabled],
[2 Sectors], [4 Sectors], [8 Sectors], or [16 Sectors].
LBA Mode Control
Enables or disables the Logical Block Address (LBA) instead of the Cylinders, Headers, and Sectors. When
the [Type] is [None], nothing is displayed. When [Type] is [Auto], the selection is disabled. In other cases,
select from [Disabled] or [Enabled].
32 Bit I/O
Specifies an enabled/disabled state for the 32 bit transferring between CPU and IDE controller. Select from
[Enabled] or [Disabled]. When the [Type] is [None], nothing is displayed.
• Select [Auto] to have the PS-A recognize the hardware properly.