Proface APL3000B - Node Box PC - Manual (Page 66)

Chapter 3 Installation and Wiring
3-21
(4) Insert each pin terminal into its hole. Release the Opening button to clamp the pin place.
(5) After inserting all three pins, insert the Power Plug into the PS-A unit’s Power Connector. Attach the
plug with two (2) slot screws.
„DC Power Supply Type
Power Cord Specifications
• Confirm that all wires are connected correctly.
• The torque required to tighten these screws is 0.5 to 0.6N•m.
• To prevent the possibility of a terminal short, use a pin terminal that has an
insulating sleeve.
Power Cord Diameter
0.75 to 2.5mm
2
(18 to 12 AWG)
Conductor Type Solid or Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are not twisted correctly, the end
wires may either short against each other, or against an electrode.
Conductor Length
• Use copper conductors only.
L
N
FG
Opening Button
Black
White
Green/Yellow
AC power supply cord
10mm[0.39in.]