Progressive International Electronics PIcon Console - Manual (Page 7)

PIcon General Information & Warranty
Rev 2.0 June 2006 Page 3
PIcon Manufacturer's Warranty
Progressive International Electronics, Inc. (SELLER) warrants to the Purchaser of the PIcon fuel control equipment
manufactured by Seller against defects in m aterial or workmanship for one (1) year from date of shipm ent. Seller
will replace or repair defective parts or replace and issue credits to the Purchaser's account in accordance with the
following Conditions of W arranty.
CONDITIONS OF W ARRANTY
1. Credit will be applied only when the completed warranty request form and the defective parts are received and
inspected.
Decisions to repair or replace defective equipment are solely at the discretion or PIE.
2. W hen parts shipments are made prior to receiving the required warranty request and defective parts, they will be
billed to the Purchaser.
3. In all cases, approved warranty requests will be expedited by issuing the appropriate credit to the Purchaser's
account and shipping replacem ent parts.
4. Credits will not be issued for parts and no cash refunds for warranty credits will be made.
5. All components and parts must be returned to the factory prepaid, and in turn, replacement components and
parts will be returned prepaid by the factory.
6. Seller's warranty applies only if the equipment has been installed and used in accordance with Seller's
instructions. The warranty is void if any unauthorized alteration or addition has been made to the equipment or
if it has been subject to damage caused by abuse, misapplication, accident or improper operation.
7. The Seller's liability for any dam ages, including contribution and indemnification, arising out of or in any way
connected with the supplying of the equipment or its use, shall not in any case exceed the cost of repair of the
equipment as herein provided. Upon expiration of the warranty, all such liability, as well as any other liability,
shall terminate.
8. Nothing contained herein shall make the Purchaser, its agents or employees, an agent or representative of Seller
and Seller assumes no responsibility of any act, omission, representation or warranty by the Purchaser or anyone
else except as expressly stated herein.
9. The final Decision as to the validity of any claims arising under the warranty shall be determined solely by the
Seller.
THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER W ARRANTIES, EXPRESSED OR IM PLIED,
INCLUDING, BUT NOT LIM ITED TO, THE IM PLIED W ARRANTIES OR M ERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE WHICH EXCEED THE AFORESAID OBLIGATIONS AND ARE
HEREBY DISCLAIM ED AND EXCLUDED BY SELLER.
W A R N I N G
W arning: Installation must comply with the National Electrical Code, as well as Federal, State, Local and all
applicable codes.
W arning: High voltages are present in this equipment. Disconnect all power before making installation to prevent
personal injury or equipm ent damage.
W arning: Do not install PIcon units in a volatile, combustible or explosive atmosphere. All PIcon units must be
protected from severe vibration, extreme temperatures and excessive humidity.
Any peripheral equipment is to be installed over a non-hazardous location.
Any peripheral equipment connected to the PIcon must be UL listed and using standard RS232 or RS485
communication.
The PIcon must be plugged into a dedicated 115 VAC wall socket with bonded earth ground.