Progressive International Electronics PIcon Console User Manual
Page 26
PIcon
Program & Report
Rev 2.0
June 2006
Page 22
Exit Mode 2 by pressing the
entry prompt. To exit programming mode completely and return to operator mode, press the
Mode 3 — Beeper Settings
(Manager only)
Mode 3 is used to program single or continuous beeps for Handle, Collect and Drive-Away.
(Note: The console defaults to a single beep unless set otherwise.) To enter Mode 3 from M
0, the mode number prompt, enter <3> on the numeric keypad and press
Handle/Call for Service — The display first will prompt for selection of the style of
beep associated with a Handle/Call for Service. To change the style of beep, press the
key and toggle between single and continuous. To proceed to the next
option setting, press
Collect — The display now prompts for selection of the style of beep associated with a
Collect condition. To change the style of beep, press the key and toggle
between single and continuous. To proceed to the next option setting, press the
Drive-Away — The display now prompts for selection of the style of beep associated
with a Drive-Away condition. To change the style of beep, press the key
and toggle between single and continuous.
Exit Mode 3 by pressing the
display. To exit programming mode completely and return to operator mode, press the