Progressive International Electronics PIcon Console - Manual (Page 23)

PIcon Program & Report
Rev 2.0 June 2006 Page 19
Mode Descriptions
The sequence for manager access must be completed before programming features can be
utilized through the various program modes. The sequence for either manager access or operator
access allows generation of reports (Modes 10 and 11). Each set of instructions for the following
program and report modes assumes that the appropriate manager/operator access has already
been executed and that the mode number (M 0) prompt now appears in the display. To operate
the PIcon, Modes 1 and 2 (at least) must be programmed.
Mode 1 — Dispenser Setup Information (Manager only)
In Mode 1, hose selection, product, service, blend and slowdown amount are entered for each
dispenser/fueling position controlled by the PIcon. After being prompted for mode number
(M 0), press <1> on the numeric keypad and then press . You are now in Mode 1.
To initiate dispenser programming, press the key for the first dispenser/fueling
position at the site (usually Dispenser #1).