4 cabinet and rack installation, Figure 3-17: arm mounting retention screw holes – IEI Integration AFL-F08A v1.01 User Manual

Page 44

AFL-F08A Panel PC

Page 32

Step 3:

Align the retention screw holes on the mounting arm interface with those in the

flat panel PC.

Figure 3-17: Arm Mounting Retention Screw Holes

Step 4:

Secure the system to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel PC.

Step 0:

3.8.4 Cabinet and Rack Installation

The AFL-F08A can be installed into a cabinet or rack. The installation procedures are

similar to the panel mounting installation. To do this, please follow the steps below:

NOTE:

When purchasing the cabinet/rack installation bracket, make sure it is

compatible with both the AFL-F08A and the rack/cabinet into which the

AFL-F08A is installed.

Step 1:

Slide the rear chassis of the AFL-F08A through the rack/cabinet bracket until the

aluminum frame is flush against the front of the bracket (Figure 3-18).