ZOLL R Series Monitor Defibrillator Rev K Operators Guide - Manual (Page 148)

A PPENDIX A S PECIFICATIONS
A–8 www.zoll.com 9650-0912-01 Rev. K
Electromagnetic Immunity Declaration (EID)
Guidance and manufacturer’s declaration — electromagnetic immunity for the R Series.
The R Series is intended for use in the electromagnetic environment specified below. The customer or user of
the R Series should ensure that it is used in such an environment.
Immunity test IEC 60601 test level Compliance level
Electromagnetic environment –
guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2 ±6 kV contact
±8 kV air ±6kV contact
±8 kV air Floors should be wood, concrete, or
ceramic tile. If floors are covered with
synthetic material, the relative
humidity should be at least 30%.
Electrical fast
transient/burst
IEC 61000-4-4 ±2 kV for power supply
lines
±1 kV for input/output
lines ±2 kV for power
supply lines
Not applicable Mains power quality should be that of
a typical commercial or hospital
environment.
Surge
IEC 61000-4-5 ±1 kV differential mode
±2 kV common mode ±1 kV differential
mode
±2 kV common mode Mains power quality should be that of
a typical commercial or hospital
environment.
Voltage dips,
short interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11 <5% U
T
(>95% dip in U
T
)
for 0.5 cycle
40% U
T
(60% dip in U
T
)
for 5 cycles
70% U
T
(30% dip in U
T
)
for 25 cycles
<5% U
T
(>95% dip in U
T
)
for 5 seconds
<5% U
T
(>95% dip in
U
T
) for 0.5 cycle
40% U
T
(60% dip in
U
T
) for 5 cycles
70% U
T
(30% dip in
U
T
) for 25 cycles
<5% U
T
(>95% dip in
U
T
) for 5 seconds
Mains power quality should be that of
a typical commercial or hospital
environment. If the user of the
R Series requires continued operation
during power mains interruptions, it is
recommended that the R Series be
powered by an uninterruptible power
supply or a battery.
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8 3 A/m 3 A/m Power frequency magnetic fields
should be at levels characteristic of
typical location in a typical commercial
or hospital environment.
NOTE: U
T
is the AC mains voltage prior to the application of the test level.