beautypg.com

Removing the front enclosure module – ZOLL Propaq M Rev A User Manual

Page 51

background image

Removing the Front Enclosure Module

9650-0804-01 Rev. A

ZOLL Propaq M Service Manual

47

Removing the Front Enclosure Module

Tools Required

#2 Phillips screwdriver with torque capability

Orange (wooden) stick

Setup

This procedure should be conducted on a static mat.

Wear a wrist strap to ground during the procedure.

Complete these procedures in the following order before performing this procedure:

1.

“Removing the Handle” on page 43

2.

“Disassembling the Main Unit” on page 44

To reinstall the front enclosure module, reverse the steps.

Front Enclosure Disassembly

1

Remove tape from the top of the unit.

2

Separate monitor front enclosure.

3

Pivot top up with cables still connected.

4

Remove grounding screw as shown in the
illustration.

Note: During reassembly, torque screw to 6
in-lbs.

5

Disconnect the front panel multi-wire cable
in the area illustrated.

grounding
screw

multi-wire
cable