Warner Electric PB-650 Pin Drive - Manual (Page 12)

12 Warner Electric • 800-825-9050 819-0485
Parts List for kit 5200-101-010
Item Quantity Part Name
1 1 Bracket
2 1
Screw, Hex, Washer Head
and Sems Conical Washer
3 1 Box, Conduit
4 3 Screw, Hex, Washer Head
5 1 Plug, Protective
6 2 Grommet, Wire
*7
2 Spacer No. 8 Thd.
2 Spacer No. 6 Thd.
8 2 Cap terminal
9 1
Screw, Hex, Washer Head,
Green
9-1 3 Terminal, Ring
10 1 Cover
11 2 Screw, No. 8 Brass
12 1 Plug, Protective
*The No. 6 spacers are required on Sizes 375, 400 and 475. All
others use No. 8.
4
10
8
11
9-1
*7
3
6
5
9
9-1
12
2
1
4
Components Conduit Box
Installation Instructions
Conduit box kit No. 5200-101-010 contains all
components needed to assemble a conduit box
for PB500 and PB650 brake.
When properly installed, this conduit box is
designed to provide a proper means for field
wiring terminations. It conforms to the require-
ments of Underwriters Laboratories.
Do not connect rigid conduit
directly to the conduit box. A minimum of 12”
of flexible liquid tight conduit or other suitable
flexible wiring with appropriate fittings is
required. Flexible wiring is required to prevent
side loading of bearing on bearing mounted
clutches and possible deformation or
breakage of the conduit box or clutch/brake
components during assembly.
Step 1
Assemble a customer supplied flexible wiring
connector into desired end of conduit box (3).
Press protective plug (5) into unused conduit
hole.
Thread green washer head hex screw (9) into
round hole in base of conduit box. Place terminal
ring (9-1) over screw before inserting.
Snap two wire grommets (6) into square holes in
conduit box base. The grommet crowns should
be toward the outside of the box and the rubber
flanges should be on both sides of the conduit
box.
Push two terminal spacers (7) through rubber
grommets using the correct terminal spacers.
(See Figure 10)