Warner Electric PB-650 Pin Drive - Manual (Page 9)

9 Warner Electric • 800-825-9050 819-0485
Drive
Pin
Conical
Spring
Retainer
Detent
Spring
Straight
Spring
Armature
Armature
Boss
Armature
Hub
Figure 4
Step 1
Place straight springs over armature bosses on
back side of armature. (Figure 5)
Figure 5
Step 2
Place armature hub over straight springs.
Straight springs must fit into
grooves in armature hub. (Figure 6)
Figure 6
Step 3
Compress conical spring against retainer ring by
sliding detent spring towards head of pin. (All 4
pins) (Figure 7)
Figure 7
Step 4
Insert assembled drive pins through armature
hub, through the straight springs, and into the
threaded armature bosses. Apply grade "AA"
Loctite Sealant on drive pin threads. (Figure 8)
Figure 8
The assembly procedure for the autogap
accessory is as follows: