Vanguard EZCT-S2 - Manual (Page 40)

EZCT S2 USER’S MANUAL REV 3
36
3.4.4. Erasing Test Plans From the Flash EEPROM
To erase one or all test plans from the EZCT S2’s Flash EEPROM:
a. Start from the “START-UP” menu:
Press the [3] key (TEST PLANS).
b. The following screen will be displayed:
Press the [4] key (NEXT PAGE).
c. The following screen will be displayed:
Press the [3] key (ERASE TEST PLAN).
d. The following screen will be displayed:
1. ERASE SINGLE PLAN
Press the
[1]
key if you would like to erase a single test plan. The following
screen will be displayed:
Type the test plan number that you would like to erase and press the [ENTER]
key.
ERASE TEST PLAN
NUMBER:
ERASE TEST PLAN
1. ERASE SINGLE PLAN
2. ERASE ALL PLANS
1. EXTRACT TEST PLAN
2. PRINT TEST PLAN
3. ERASE TEST PLAN
1. LOAD TEST PLAN
2. UNLOAD TEST PLAN
3. PLAN DIRECTORY
4. NEXT PAGE
1. RUN TEST 12/04/09
2. SETUP 09:39:19
3. TEST PLANS
4. DIAGNOSTIC