Vanguard EZCT-2000A User Manual

Page 94

EZCT-2000A USER’S MANUAL

REV 1

d. You will also receive an email confirming the receipt of your download request. Once

your request has been received, you will receive a second email, usually within 1-2
business hours, containing a download link for the firmware file. Click on this link and
download the firmware file to your computer.

e. The downloaded file will be in ZIP compressed format. Unzip this file to an empty

directory (you can use a utility like Winzip, 7Zip, Winrar, etc.). Once un-compressed, you
should see a file named EZCT2A_M.hex. Copy this file to the root of a USB Flash drive.

f. Make sure the EZCT-2000A’s power if OFF, and then insert the USB Flash drive

containing the firmware file in the EZCT-2000A’s Flash drive interface port (“USB MEM”
port).

g. While holding down the

[STOP]

key, turn on the EZCT-2000A.

h. Continue to hold down the

[STOP]

key while the EZCT-2000A powers up.

i. After the initial logo screen, the following screen will be displayed:

Continue to hold down the

[STOP]

key.

j. The firmware upgrade process will start and the following screen will be displayed:

You can release the

[STOP]

key at this point. The EZCT-2000A will continue the

upgrade process and display the following screen:

erasing ext 4

loading code
from flash drv.

start handshake
or
insert thumb drv.