Vanguard EZCT-2000A User Manual
Page 72
EZCT-2000A USER’S MANUAL
REV 1
68
3.5.9. Running a Test Using a Loaded Test Plan
Once a test plan has been loaded into the working memory (see sections 3.5.7 and 3.5.8 for
directions), it can be used to run a test. To run a test using a loaded test plan:
a. Make sure a test plan has been loaded into the working memory and then start from the
“START-UP” menu:
Press the
[1]
key (RUN TEST).
b. The following screen will be displayed (this screen will be displayed only if a test plan
has been loaded first):
1. RUN WITH PROMPTS
Press the
[1]
key to run the test with prompts. Continue to step c.
2. RUN AUTONOMOUSLY
Press the
[2]
key to run the test autonomously. The following screen will be
displayed:
Press the
[START]
key and the EZCT-2000A will start running the test per the
test plan settings. The screen will be updated with the test status.
CABLES WILL BE
ENERGIZED!
"START" TO BEGIN
TEST PLAN LOADED
1.
RUN WITH PROMPTS
2.
RUN AUTONOMOUSLY
3.
UNLOAD TEST PLAN
1.
RUN TEST 02/16/10
2.
SETUP 10:24:25
3.
TEST PLANS
4.
DIAGNOSTIC