Vanguard EZCT-2000A - Manual (Page 48)

EZCT-2000A USER’S MANUAL REV 1
44
3.4.7. Erasing Test Records From the Flash EEPROM
You can erase individual or all test records stored in the EZCT-2000A’s Flash EEPROM. To erase
a test record:
a. Start from the “START-UP” menu:
Press the
[2]
key (SETUP).
b. The following screen will be displayed:
Press the [5] key (ERASE RECORD).
c. The following screen will be displayed:
NOTE
The above screen will be displayed only if a USB Flash drive is NOT connected
to the EZCT-2000A’s USB Flash drive port. If a USB Flash drive is connected,
the following screen will be displayed:
Press the [1] key (ERASE INTERNAL REC). The following screen will be
displayed:
1. ERASE INTERNAL REC
2. ERASE THUMB DRV REC
ERASE RECORD
1. ERASE SINGLE REC.
2. ERASE ALL RECORDS
1. RECORD ID
2. PRINT RECORD
3. RECORD DIRECTORY
4. SAVE/RES RECORD
5. ERASE RECORD
6. NEXT PAGE
1. RUN TEST 02/16/10
2. SETUP 10:24:25
3. TEST PLANS
4. DIAGNOSTIC