Vanguard CT-7000 - Manual (Page 72)

CT-7000 Operating Instructions
65
Problems Suggestion
9. How does one review the current analysis setting?
n Go to SETUP (Press key #3).
n Select Analysis (Press key #1).
n Select PRINT SETTING (Press key #3). The CT-7000
will print out the current AP1 & AP2 settings.
10. The CT-7000 will not communicate with the PC.
n
Make sure the CT-7000 is under computer control
mode.
n Make sure your PC communication port is selected
correctly.
n Make sure your serial cable is connected properly.
11. Turn on Automatic Print Results mode.
n See section 9.21.
12. Where can one get some thermal paper?
n Call the factory at 909-923-9390 or BG Instruments
at 509-893-9881. The CT-7000 uses TP-4 thermal
paper.
n In case of an emergency, thermal paper can be
purchased at Radio Shack. Radio Shack carries 4.25
inch wide thermal paper. It is not the right size but it will
work.
13. How does one darken or lighten the LCD?
n Press and hold the “ ↑
PAPER LCD” key will darken
the LCD.
n Press and hold the “
↓
PAPER LCD” key will lighten
the LCD.
14. How does one move thermal paper forward or
backward?
n Press and release the “ ↑
PAPER LCD” key, the
thermal paper will advance.
n Press and release the “
↓
PAPER LCD” key, the
thermal paper will retract.