Teledyne LeCroy WaveStation SCPI Command Reference Manual - Manual (Page 6)

WaveStation SCPI
Table of Commands & Queries
Short Long Subsystem What It Does
*IDN? *IDN SYSTEM Retrieves device identification information.
*OPC *OPC SYSTEM Sets the Event Status Register (ESR) OPC bit to TRUE (1).
*CLS *CLS SYSTEM Clears all status data registers
*ESE *ESE SYSTEM Sets the Standard Event Status Enable register (ESE)
*ESR? *ESR? SYSTEM Reads and clears the contents of the Event Status Register
(ESR)
*RST *RST SYSTEM Initiates a device reset.
*SRE *SRE SYSTEM Sets the Service Request Enable register (SRE)
*STB? *STB? SYSTEM Reads the contents of the 488.1 defined status register (STB),
and the Master Summary Status (MSS)
*TST *TST SYSTEM Performs an internal self-test.
*WAI *WAI SYSTEM Wait to continue command.
ARWV ARBWAVE SYSTEM Sets the instrument to an arbitrary waveform or retrieves Arbitrary
Waveform settings.
BSWV BASIC_WAVE SIGNAL Sets or retrieves basic wave parameters.
BTWV BURSTWAVE SIGNAL Sets instrument to a burst waveform or retrieves current Burst
Wave settings.
BUZZ BUZZER SYSTEM Sets or retrieves buzzer status.
CHDR COMM_HEADER Sets or retrieves the query return format.
INVT INVERT SIGNAL Sets or retrieves the phase of the output signal.
MDWV MODULATEWAVE SIGNAL Sets instrument to a modulated waveform or retrieves current
Modulate Wave settings.
OUTP OUTPUT SIGNAL Sets or retrieves output state.
PACP CHANNEL_COPY SIGNAL Copies parameters from one channel to the other
ROSC ROSCILLATOR SIGNAL Sets or retrieves the clock source.
SCFG SYSTEM_CONFIG SYSTEM Sets or retrieves the state used (last or default) when powering on
the WaveStation.
SCSV SCREEN_SAVE SYSTEM Sets screen saver on/off or retrieves screen saver status.
4 922829 Rev C