Teledyne LeCroy WaveStation SCPI Command Reference Manual - Manual (Page 18)

WaveStation SCPI
Parameters Value Description
MEAN
Parameter is valid only when WVTP is NOISE. Where := {default unit is
V; range depends on }.
WIDTH Value of width. Parameter is valid only when WVTP is PULSE.
RISE Value of rise. Parameter is valid only when WVTP is PULSE.
FALL Value of fall. Parameter is valid only when WVTP is PULSE.
DLY
Where := {default unit is S; minimum 0, maximum is Pulse Period}.
Parameter is valid only when WVTP is PULSE.
QUERY SYNTAX
:BaSicWaVe?
:= {C1|C2}
RESPONSE
:BSWV ,,,,,
,
EXAMPLE 1 Set Channel 1 basic wave type to Ramp.
C1:BSWV WVTP,RAMP
EXAMPLE 2 Set Channel 1 signal frequency to 2000Hz.
C1:BSWV FRQ,2000HZ
EXAMPLE 3 Retrieve Channel 1 Basic Wave settings.
C1:BSWV?
Return:
C1:BSWV TYPE,SINE,FRQ,1000,AMP,3,OFST,3
RELATED ARWV, BTWV, CFG, CPL, MDWV, SWWV
16 922829 Rev C