Teledyne LeCroy WaveStation SCPI Command Reference Manual - Manual (Page 15)

Command Reference
*STB? – Status Register Query
DESCRIPTION The *STB? query reads the contents of the 488.1 defined status register (STB), and
the Master Summary Status (MSS). The response represents the values of bits 0 to
5 and 7 of the Status Byte register and the MSS summary message.
The response to a *STB? query is identical to the response of a serial poll except
that the MSS summary message appears in bit 6 in place of the RQS message.
SYNTAX
*STB?
RESPONSE
*STB
: = 0 to 255
RELATED ALL_STATUS, *CLS, *PRE, *SRE
*TST? – Test Query
DESCRIPTION The *TST? query performs an internal self-test, the response indicating whether
the self-test has detected any errors.
SYNTAX
*TST?
RESPONSE
*TST {0|1}
Where:
0 = self-test successful
1 = self-test failed
RELATED *CAL
*WAI – Wait Command
DESCRIPTION The *WAI (WAIt to continue) command is required by the IEEE 488.2 standard but
has no effect on the WaveStation, as the signal generator only starts processing a
command when the previous command has been entirely executed.
SYNTAX
*WAI
RELATED *OPC
922829 Rev C 13