Teledyne LeCroy WaveStation SCPI Command Reference Manual - Manual (Page 25)

Command Reference
OUTP - Output Command
DESCRIPTION Enables or disables the output connector on the front panel for a specified
channel. The query returns a value of ON or OFF.
SYNTAX
:OUTPut ,,…
:= {C1|C2}
:= {a parameter from table below}
Parameters Value Description
ON --- Turn on channel
OFF --- Turn off channel
LOAD {50|HZ} 50 = low-impedance (50 Ohm); HZ = high-impedance(Hi-Z)
PLRT {NOR|INVT} NOR = normal polarity; INVT = inverted
QUERY SYNTAX
:OUTPut?
RESPONSE
:OUTPut {ON|OFF},LOAD,
EXAMPLE 1 Turn on Channel 1 output
C1:OUTP ON
EXAMPLE 2 Read Channel 1 output state
C1:OUTP?
Return:
C1:OUTP ON,LOAD,HZ
EXAMPLE 3 Set Channel 1 load to 50 Ohm
C1:OUTP LOAD,50
PACP - Channel Parameter Copy Command
DESCRIPTION Copies all parameter data from one channel to the other.
SYNTAX
PAraCoPy ,
:= {C1|C2}
:= {C1|C2}
IMPORTANT: Destination and source must both be set and cannot be the same. If C1 is the destination
channel, C2 is the source channel and vice versa.
RELATED ARWV, BTWV, CFG, CPL, MDWV, SWWV, CHCT, BSWV
922829 Rev C 23