Teledyne LeCroy WaveStation SCPI Command Reference Manual - Manual (Page 20)

WaveStation SCPI
Parameters Value Description
(CARR,)AMP
Where carrier wave := {default unit is V;
WS2000 Channel 1 min. 0.004V max. 6V, Channel 2 min. 0.004V max. 20V
WS3000 Channel 1 and 2 min. 2mVpp max. 20Vpp}.
(CARR,)OFST
Where carrier wave := {default unit is V; maximum value depends on
the WaveStation model}.
(CARR,)SYM Where carrier wave := {0% to 100%}.
(CARR,)DUTY
Where carrier wave := {if CARR,WVTP is SQUARE, 20% to
80%; if CARR,WVTP is PULSE, 0.1% to 99.9%}.
(CARR,)PHSE Where carrier wave := {0 to 360}.
(CARR,)RISE Value of carrier wave rising edge. Parameter valid only when CARR,WVTP
is PULSE.
(CARR,)FALL Value of carrier wave falling edge. Parameter valid only when CARR,WVTP
is PULSE.
(CARR,)DLY
Where carrier wave := {default unit is S; minimum 0, maximum is
value of Pulse Period}. Parameter is valid only when CARR,WVTP is
PULSE.
(CARR,)STDEV
deviation>
Parameter is valid only when CARR,WVTP is NOISE.
(CARR,)MEAN Parameter is valid only when CARR,WVTP is NOISE.
QUERY SYNTAX
:BursTWaVe?
RESPONSE
:BursTWaVe ,,
EXAMPLE 1 Set Channel 1 burst waveform period to one second.
C1:BTWV PRD,1S
EXAMPLE 2 Read Channel 2 burst waveform parameters (and STATE is ON).
C2:BTWV?
Return:
C2:BURSTWAVE STATE,ON,PRD,0.01S,STPS,0,TRIG,IN,TRMD,OFF,
TIME,1,DLAY,2.4e-07S,GATE_NCYC,NCYC,PLRT,NEG,CARR,WVTP,SINE,
FRQ,1000HZ,AMP,4V,OFST,0V,PHSE,0
EXAMPLE 3 Read Channel 2 burst wave parameters (and STATE is OFF).
C2:BTWV?
Return:
C2:BURSTWAVE STATE,OFF
18 922829 Rev C