Teledyne LeCroy Sierra Port Configurations Reference Manual - Manual (Page 10)

Teledyne LeCroy Corporation Sierra M6-4 and Sierra M6-2 Port Configurations Reference Manual
4 4
1.4 Sierra Setup Examples
1.4.1 Example 1: Composite Configuration with Analyzer,
Host Emulation, and Jammer
Ports configuration:
Port 1 Port 2 Port 3 Port 4
- -
Setup:
Port 1 of Target connects to a drive (DUT 2) by an “Octopus” cable. Using Host Emulator and Analyzer on
Port 1 allows host emulation and analysis on this link. However, this link does not have error injection.
Port 3 of Initiator connects to the Host DUT by a mini-SAS cable.
Port 3 of Target connects to a drive (DUT 1) by an “Octopus” cable.
The Host DUT can talk to a drive (DUT 1) on Port 3 of Target on an “Octopus” cable.
Using Jammer on Port 3 allows traffic corruption on this link. However, this link has no capturing or
analysis.
Description:
Port 1 is configured as a Host Emulator. Port 1 traffic is recorded (analyzed) in both the emulated Host
direction and the received Target direction.
Port 3 is configured to impair or corrupt incoming traffic and output it back. In this configuration, this
traffic is not recorded.
Ports 2 and 4 are not used.
Figure 1-2 Example 1: Composite configuration involving Analyzer, Host Emulation, and Jammer
DUT 2 DUT 1
Host DUT
on Port 3
Mini-SAS
cable
“Octopus”
cable
Port 1
Port 3