Acer 230 - Manual (Page 53)

Chapter 2 45
PCI IRQ Routing
The PCI IRQ Routing sub-menu allows you to set IRQ for PCI devices.
CAUTION: The parameters in this screen are for advanced users only. Typically, you do not need to change
the values in this screen because these values are already optimized.
Parameter Description Options
PIRQ A-H# Set default IRQ of PCI device.
Help: PCI devices can use hardware interrupt called
IRQs. A PCI device cannot use IRQs already in use
by ISA or EISA devices. Use “Auto” only if no ISA or
EISA legacy cards are installed.
IRQ 10 or IRQ11, Disabled,
Auto Select, IRQ3, IRQ7
PhoenixBIOS Setup Utility
Advanced
PCI IRQ Routing Item Specific Help
PIRQ A# :[11]
PIRQ B# :[10]
PIRQ C# :[11]
PIRQ D# :[10]
PIRQ E# :[11]
PIRQ F# :[10]
PIRQ G# :[11]
PIRQ H# :[10] PCI devices can use
hardware interrupts called
IRQs. A PCI device
cannot use IRQs already
in use by ISA or EISA
devices. Use ‘Auto’ only if
no ISA or Eisa legacy
cards are installed.
F1 Help Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select > Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Advanced
PhoenixBIOS Setup Utility
Advanced
PhoenixBIOS Setup Utility
Advanced
PCI IRQ Routing PCI IRQ Routing Item Specific Help Item Specific Help
PIRQ A# :[11]
PIRQ B# :[10]
PIRQ C# :[11]
PIRQ D# :[10]
PIRQ E# :[11]
PIRQ F# :[10]
PIRQ G# :[11]
PIRQ H# :[10] PIRQ A# :[11]
PIRQ B# :[10]
PIRQ C# :[11]
PIRQ D# :[10]
PIRQ E# :[11]
PIRQ F# :[10]
PIRQ G# :[11]
PIRQ H# :[10] PCI devices can use
hardware interrupts called
IRQs. A PCI device
cannot use IRQs already
in use by ISA or EISA
devices. Use ‘Auto’ only if
no ISA or Eisa legacy
cards are installed. PCI devices can use
hardware interrupts called
IRQs. A PCI device
cannot use IRQs already
in use by ISA or EISA
devices. Use ‘Auto’ only if
no ISA or Eisa legacy
cards are installed.
F1 Help Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select > Sub-Menu F10 Save and Exit
F1 Help Select Item F5/F6 Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select > Sub-Menu F10 Save and Exit