Teledyne LeCroy IBTracer 4X - Users Manual Ver.2.20 - Manual (Page 21)

13
IBTracer 4X Protocol Analyzer User’s Manual CATC SW Version 2.2
Warning: Do not open the UPAS enclosure. There are no
user-serviceable parts inside. Refer servicing to CATC.
3.3 IBTracer 4X System Setup
IBTracer 4X and UPAS are connected via USB to a desktop or laptop PC.
The PC, in turn, is used to administer the Analyzer and display traces.
To set up the Analyzer and PC,
Step 1
If needed, insert the IBTracer 4X module into the UPAS.
Step 2
Connect the UPAS to an AC power source.
Step 3
Connect the Analyzer to the analyzing PC via USB.
Step 4 Connect InfiniBand cables to the devices under test.
Step 5
Install IBTracer software.
Step 6
Create a recording.
3.4 AC Power Source
Step 1 Connect the Analyzer box to a 100-volt to 240-volt, 50 Hz to 60 Hz,
165 W power outlet using the provided power cord.
Note
The Analyzer is capable of supporting supply voltages between
100-volt and 240-volt, 50 Hz or 60 Hz, thus supporting all
known supply voltages around the world.
Step 2
Use the power switch located on the rear panel to turn the analyzer
unit on and off.
Note At power-on, the Analyzer initializes itself in a few seconds and
then performs an exhaustive self-diagnostic that lasts about 20
seconds. The Status LED illuminates during the power-on
testing and turns off when testing is finished. If the diagnostics
fail, the Status LED blinks, indicating a hardware failure. If this
occurs, call CATC Customer Support for assistance.