Teledyne LeCroy IBTracer 4X - Users Manual Ver.2.20 - Manual (Page 16)

8
IBTracer 4X Protocol Analyzer User’s Manual CATC SW Version 2.2
2.3 Installing the Software
Step 1
Run the setup program (for example, Start > Run > d:\setup) and
follow the on-screen instructions to install the IBTracer application
on the analyzing PC hard disk.
Step 2 To start the application, launch the CATC IBTracer 4X program
from the Start Menu: Start>Programs>CATC>IBTracer.
2.4 Your First InfiniBand Recording
After installing and launching the software, you can test IBTracer 4X by
following these steps:
Step 1 Plug in a InfiniBand cable to each of the two ports on the IBTracer
4X module, and then connect the other ends to the device under test.
Step 2
Select Recording Options under Setup on the Menu Bar.
Step 3
Select the General tab.
The following dialog box will open showing factory default settings
such as “Snapshot” and 16 Mbytes buffer size. For your first
recording, you can leave these settings unchanged.
Step 4 Click OK to activate the recording options you selected.
Step 5
Turn on the InfiniBand devices that are to be tested and cause them
to generate InfiniBand traffic.